Yamato Scientific HC200 Cool Block - Manual (Page 49)

47
Deleting a Program
With the program edit function, you can delete the registered programs by their number.
CAUTION : With this function, you cannot check the parameters of the program that you are going to
delete.
As an example, this paragraph discusses how to delete Program 1.
Indication after Step/Step Procedure Explanation
Load the program number that you want to delete.
1. Push either the ▼ key or the ▲ key after
pushing the MODE key.
•
Push the MODE key to activate the function selection
mode, and push either the ▼ key or the ▲key.
⇒ ⇒ ⇒ ⇒ The controller turns to the program delete selection
mode. The main display flashes .
⇒ ⇒ ⇒ ⇒ The sub display shows the number of existing
programs.
2. Push the ENTER key.
•
Push the ENTER key.
⇒ ⇒ ⇒ ⇒ The controller turns to the program delete selection
mode. The main display flashes the lowest program
number registered.
In the example on the left, the main display shows
(Program 1).
⇒ ⇒ ⇒ ⇒ The sub display shows .
3. Push the ENTER key.
The display returns to the screens shown just before
you have pushed the MODE key.
•
Push the ▼ key to flash the program number that you
want to delete, and push the ENTER key to accept
your selection.
⇒ ⇒ ⇒ ⇒ As you are going to delete Program 1 in this
example, simply push the ENTER key.
⇒ ⇒ ⇒ ⇒ The controller deletes Program 1, and the displays
return to the screens shown just before you have
pushed the MODE key.
(Ex., 2 programs existing)