Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 79)

Publication 2711-UM014G-EN-P - September 2008 79
Configuring the Terminal Chapter 3
Last Chassis (ready only)
Indicates whether the terminal occupies the last module group in its
assigned rack.
Baud
Steps through the communication rates with each key press: 57.6K
(default), 115.2K, and 230.4K. The selected rate takes effect
immediately. The maximum cable length is restricted at higher
communication rates.
Exit
Returns to the Configuration Mode menu.
ControlNet Communication
The ControlNet screen lets you display communication settings for a
ControlNet terminal. You are only allowed to change the Node
Address and Underscan Delay settings.
IMPORTANT
Settings downloaded with a ControlNet application take
priority over terminal settings and take effect immediately after
the download.
New Node Address F2:
F16
EXIT
Terminal
Restart
F1
ControlNet
##
Active Node Address:
Interscan Delay F3:
03
100
FW Revision: ########
Channel
Status
Comms
Status
Channel B
Connected
ms
EXIT
Serial #: ########