Rockwell Automation 9323-S5500D A.I. SERIES MICROLOGIX 1000 AND PLC-500 SOFTW - Manual (Page 397)

Channel Configuration
16-19
6. Press [F1] Accept to accept the change (if you made a change to Channel 1’s
mode).
7. Press [F5] Ch1Sys . The Channel 1 Configuration screen appears. (The screen
shown here is for a SLC 5/04 processor)
8. Edit the parameters. Refer to the tables below for a description of the parameters.
§ Move the highlight to the parameter you want to change.
§ Either press [F9] Select to toggle the setting of the parameter or (if the
message Enter CFG value: appears near the bottom of the screen) type the
numeric value for the parameter.
§ When you have set the parameters the way you want them, press [F1] Accept .
9. Press [Esc] .