Metrohm 838 Advanced Sample Processor Installation Instructions - Manual (Page 42)

3.3 Fitting the accessories
36 Metrohm 838 Advanced Sample Processor, Installation
3.3.17 Installing the catch pan
The 6.2711.060 catch pan is available as an optional accessory. It pre-
vents escaping fluid spreading over the laboratory bench or penetrating
the interior of the instrument.
Figure 28 Catch pan
Attach the supplied tubing to the drain connector of the catch pan. De-
tach the sample rack and move the catch pan over the turntable so that
it lies on the Sample Processor's stirrer rail. Insert the other end of the
tubing into a drain or waste canister.
3.3.18 Sample racks
Figure 29 Fitting the sample rack
Sample racks must be fitted so that
the two guide cams of the turntable
engage in the guide openings pro-
vided in the base of the rack.
After fitting a sample rack, the Sam-
ple Processor should be switched
off and then back on again so that
the magnetic code of the rack can
be read in. This is possible only if
the rack is in initial position.