Dynojet 250iPX: Installation Guide - Manual (Page 139)

P O W E R R E Q U I R E M E N T S A N D I N S T A L L A T I O N
Locations Using 50 Hz Power (Locations other than North America and Japan)
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
B-11
C ONNECTING THE D YNO
1 Turn off the main circuit breaker on the dyno. The main breaker is located in the
CPI door. Off is the down position.
2 Once you verify the voltages on the receptacle, connect the dyno to the
receptacle.
3 Connect the high pressure blowers to the dyno. For more information on
connecting the blowers, refer to your dyno installation guide.
4 Turn on the main dyno breaker.
5 Test the blowers for operation.
6 Turn on the dyno electronics and verify operation.
7 Test the control panel operations. For more information, refer to your dyno
installation guide.