Dynojet 250iPX: Installation Guide - Manual (Page 37)

I N S T A L L A T I O N
iPX Drum Module Installation
Version 2 In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
2-15
9 Secure the connector plate on either side of the iPX drum module to the dyno
drum module using the bolts removed earlier.
10 Loosen the four bolts on either side of the iPX drum module as shown in
Figure 2-8.
11 Align the iPX drum module panels until they are flush with the top of the pit floor
and the dyno drum module panels.
12 Once you have verified the panels are flush and parallel, tighten all the screws.
13 Tighten the driveline set screws.
Note: Dynojet recommends using red loctite on the set screws.
14 Install upright bar removed earlier to the side of the iPX drum module using the
two 1/4-20 screws removed earlier.
Figure 2-8: Install the Drum Module to the Dyno
PD110
secure connector plate
upright bar
loosen these bolts on both
sides of iPX drum module
dyno drum
module panel
iPX drum module
panel