Dynojet 250iPX: Installation Guide - Manual (Page 156)

In Ground Model 200iPX/250iPX Motorcycle Dynamometer Installation Guide
A P P E N D I X E
Dyno Preparation
E-6
R EMOVING THE M ONITOR S UPPORT AND J UNCTION B OX
1 Remove the left blower assembly if installed.
2 Remove the four 3/8 x 1-inch bolts and four washers securing the left blower
mount and set aside. Do not remove the blower mount.
3 Remove the right blower assembly.
4 Remove the four 3/8 x 1-inch bolts and four washers securing the support arm
and junction box to the pit floor and set aside.
5 Remove the junction box and set aside.
6 Remove the support arm and move to the left blower mount.
7 Set the right blower mount aside. This will be installed in a new location.
Figure E-5: Remove the Monitor Stand and Junction Box
PD039
support arm
blower mount
junction box
right blower mount
(under support arm)