Cub Cadet ISeries - Manual (Page 100)

STEERING-IVT
94
9. Remove the input sector gear.
See Figure 6B.42.
10. Inspect the input sector gear bushings for dam-
age and/or signs of wear. If they show signs of
wear or damage, press both of the bushings out
of the input sector gear using a press.
See Figure 6B.43.
11. Remove the internal cam and both of the wash-
ers on top of the cam. See Figure 6B.44.
NOTE: The steering shaft is pressed into the
lower housing.
12. Remove both of the bevel gears.
See Figure 6B.45.
NOTE: There may be a pocket of suction
between the bevel gear and the lower housing
because of the grease. It may be necessary to
use a pry tool to lift the bevel gear out of the
lower housing.
Figure 6B.42
Input sector gear
Figure 6B.43
Press out the
bushings
Figure 6B.44
Internal cam
Washers
Steering
shaft
Figure 6B.45
Bevel gears