Cub Cadet ISeries - Manual (Page 90)

STEERING-IVT
84
Neutral and drive control links Adjustment
IMPORTANT: Check the tire air pressure before
attempting to diagnose any problems with the
steering or tracking of an I-series tractor. If the
tire air pressures are not equal across the same
axles, it will greatly affect the performance of the
tractor.
Because the steering gear box is linked to the
transmission, it is important to make sure the transmis-
sion is adjusted for neutral first. To establish neutral:
1. Remove the steering wheel by:
1a. Remove the center cover. See Figure 6B.9.
1b. Remove the bolt with a 1/2” wrench.
See Figure 6B.10.
NOTE: There is no puller needed for the steer-
ing wheel. Once the bolt is removed it will lift off
of the steering shaft.
2. Disconnect the parking brake by removing the
hair pin clip and sliding the rod out of the lever.
See Figure 6B.11.
3. Remove the two screws attaching the dash to
the dash support. See Figure 6B.12.
Figure 6B.9
Center cover
Figure 6B.10
Remove
bolt
this
Figure 6B.11
Hair pin
clip
Rod
Figure 6B.12
One on each side