KEYENCE LK-G5000 Series - Manual (Page 19)

19
Accumulation data
4. Setting the amount of data stored
5. Starting and stopping data storage
The amount of data stored equals the number of data points that you wish to store. The storage time is equal to the amount
of data stored x the storage cycle.
* Once data storage settings have been completed, click “Send settings to controller”.
For example, when setting the amount of data stored to 10,000 points and the storage cycle to 200 μs, the storage time will equal
2 seconds (= 10,000 points x 200 μs) . The amount of data stored is configured in the settings for “Amount of Data Stored” in data storage settings.
It is possible to load up to a maximum of 12 sets of accumulated data on the same screen.
(1) Select the data set that you wish to load from “Data01 to Data12”.
(2) Once the “Read out” button is clicked, the data will be loaded.
With the data storage function, the following is possible.
• Viewing accumulation data waveforms (the horizontal and vertical axis can also be adjusted)
• Using the cursor to view number values for current value, maximum value, minimum value, and average value
• Saving accumulation data in CSV format
• Loading accumulation data that has been previously saved*
* Click “Read from File”.
Data storage waveform data
Data storage numerical data
Data storage numerical data
To start data storage, click “Start Storage” in data storage. After starting
data storage, storage will automatically finish once it has recorded the
amount of data specified in the data storage settings.
If you wish to stop during the storage process, click “Stop Storage”.
When you wish to restart collection from storage that was stopped
mid-process, click “Start storage” once again. Also, when starting data
storage from the beginning, click “Clear Stored Data” and then
“Start storage”.