Interlogix NS3702-24P-4S User Manual - Manual (Page 23)

23
■ Console Port
The console port is a RJ-45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP Address setting, factory reset, port management, link status and system setting.
Users can use the attached DB9 console cable in the package and connect to the console port on the device. After the
connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm and so on) to enter
the startup screen of the device.
■ Reset button
At the right of the front panel, the reset button is designed for rebooting the Managed Switch without turning off and on the
power. The following is the summary table of reset button functions :
Reset Button Pressed and Released Function
< 5 sec : System Reboot Reboot the Managed Switch.
> 5 sec : Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as shown below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.2 LED Indications
The front panel LEDs indicate instant status of power and system status, fan status, port links / PoE in-use and data activity; they
help monitor and troubleshoot when needed. Figure 2-1-2 shows the LED indications of the Managed Switch.
NS3702-24P-4S LED Indication
Figure 2-1-2:
NS3702-24P-4S LED at Front Panel