Corinex Global ADSL2+ - Manual (Page 110)

Appendices
Corinex ADSL2+ Wireless Gateway G
I have got all that, it still doesn’t work...
• Make sure that your TCP/IP settings are set to automatically obtaining IP address
and gateway address. If the DHCP server is not running on the network, than set
the TCP/IP configuration manually as described in the chapter 3.2.
• Switch off all computers. This will ensure that the computer’s IP address will be
obtained from the Gateway.
• Now open the web browsers, if the “Not Found“ page appears, try to check
your LAN settings in the Internet Options of your web browser.
Wireless part…
The Wireless LED does not light up on the Gateway.
• When the Wireless port detects a WLAN connection, the Wireless LED will be
blinking. Check the Wireless adapter on your computer to see if connection and
adapter work properly.
Check the Wireless configuration of the Wireless adapter on your computer.
I am getting interference between my other 2.4 GHz wireless devices and my
wireless network.
You can take several steps:
• Change the channel of the other 2.4 GHz Wireless devices or the Access Point
so that they can use different channels.
• Move wireless devices farther away from the Access Point space.
The Gateway is not functional.
1. Check that the power LED is green and than the network cables are installed
correctly. Refer to the easy start guide for more details.
2. Check that the ETH and Internet LEDs are green.
3. Check that the DSL LED is green.
4. Check the settings on your PC. Again, refer to the easy start guide for more
details.
5. Check the Gateway’s settings.
6. From your PC, can you PING the Gateway? Assuming that the Gateway has
DHCP enabled and your PC is on the same subnet as the gateway, you should be
able to PING the gateway.
109