Pilz PNOZ m B0 - Manual (Page 16)

Installation
Operating Manual PNOZ m B0
1002660­EN­03 16
INFORMATION
Please note that at the stated minimum distance, it will be difficult to swap
the chip card from above. If you cannot leave a greater distance, remove
the unit from the mounting rail to swap the chip card.
5.3 Connecting the base unit and expansion modules
Please refer to the document "System Expansion" for details of the number of modules that
can be connected to the base unit and the module types.
The modules are linked via jumpers.
} Remove the terminator on the side of the base unit and on the expansion module.
} Install the base unit and expansion modules on the mounting rail and connect the units
using the jumper supplied
} Fit the terminator to the unconnected interfaces on the base unit and expansion mod­
ule.
Terminator Terminator
IM0 IM1 IM2 I6 I5 I4 IM3 I7
I8 I10 I14 I13 I12 I11 I15
X3
X1
X4
X2
PNOZ mm0.1p
T0 T1 T2 O2 O1 O0 T3 O3
IM16 IM17 IM18 0 V A2 A1 IM19 24 V
M20 M21 M22 M23
Jumper
CAUTION!
Only connect the base unit and expansion modules when the supply voltage
is switched off.