Pilz PSSu H PLC1 FS SN SD - Manual (Page 9)

Safety
Operating Manual PSSu H PLC1 FS SN SD(­T)(­R)
21939­EN­10 9
3 Safety
3.1 Intended use
The module is suitable for use in safety and non­safety­related applications, with and
without SafetyNET p.
The modules PSSu H PLC1 FS SN SD and PSSu H PLC1 FS SN SD­T may be used as a
safety component in accordance with the Lifts Directive 95/16/EC, EN 81­1, EN 81­2 and
EN 115­1.
The programmable safety system should be installed in a protected environment that meets
at least the requirements of pollution degree 2. Example: Protected inside space or control
cabinet with protection class IP54 and corresponding air conditioning.
The module PSSu H PLC1 FS SN SD­T is suitable for use where there are increased envir­
onmental requirements (see Technical Details).
The module PSSu H PLC1 FS SN SD­R is suitable for use where there are increased en­
vironmental requirements demanded by railway applications (see Technical Details).
Intended use includes making the electrical installation EMC­compliant. Please refer to the
guidelines stated in the "PSSuniversal Installation Manual". The module is designed for use
in an industrial environment. It is not suitable for use in a domestic environment, as this can
lead to interference.
The following is deemed improper use in particular:
} Any component, technical or electrical modification to the module
} Use of the module outside the areas described in this manual
} Any use of the module that is not in accordance with the technical details.
NOTICE
Always use the latest version of PAS4000 for programming the head mod­
ules (download from www.pilz.de).
– Base type and T­type:
at least version 1.3.1.
– R­type:
at least version 1.5.0
3.2 Safety regulations
3.2.1 Use of qualified personnel
The products may only be assembled, installed, programmed, commissioned, operated,
maintained and decommissioned by competent persons.