Dan Dugan Sound Design E-2 - Manual (Page 59)

Dugan Model E-2 User Guide
59
Appendix A: Power-up Commands
The Model E-2 can execute five power-up commands that can choose essential set-
tings without being connected to a computer or iPad.
Select the command by holding down a specific button during the entire power-up
process (see table below). Power-up is complete after the LEDs stop flashing.
To execute more than one command, turn the unit off after it finishes powering up,
and repeat for the next command.
Table A-1 Power-up commands
System Reset
Hold down the channel 1 bypass button to set all parameters to factory default set-
tings and clear label text. We recommend executing this command (just like “zeroing
out” a console) before starting a new installation.
Network Reset
Hold down the channel 1 mute button to set these parameters to their default values:
*xx = last two digits of serial number, unless 00, then use 100
DHCP On
Turning DHCP on requests that the network assign an IP number to the Model E-2,
if the network has that capability. To turn DHCP on, hold the channel 2
bypass but-
ton down.
channel 1 channel 2 channel 3 channel 4
bypass System Reset DHCP On N/A 12/16 channel mode
mute Network Reset N/A N/A 8 channel mode
Model E-2
IP Address 192.168.1.xx*
Netmask 255.255.255.0
Gateway 192.168.1.254
DHCP off