Dataman 48XP - Manual (Page 44)

44
Auto-Erase/Overwrite Option
This option only applies to chips, which are electronically
erasable for example Flash memory, Flash based MCU or GAL
and so on. It causes the DATAMAN-48XP to automatically
erase a non-blank chip prior to programming (there will be no
warning message “Device is not blank, are you going to
program”).
Auto increment (only available to memory device)
This enables the auto increment function that allows a user to
program different serial numbers into the chip without editing
the buffer each time, for setup of auto increment, please refer
to the auto increment start address /end address, increment
value and format section.
Parallel Port Selection
Menu options / parallel port
Hotkey F5
This command allows the user to select which parallel port the
DATAMAN-48XP device programmer is connected to. Default
setting is auto search, after executing the DATAMAN-48XP
software, it auto detects which LPT port the DATAMAN-48XP
programmer is connected to, the user can select the LPT port
manually by specifying LPT port to avoid possible conflict
with drivers of another LPT device that is attached to the PC.