Factory reset – SMK-Link Electronics Universal Projector Remote Control User Manual
Page 10
Page 8
• Press Select, wait one second then press Select a second time.
The LED will then flash the code digit by digit with a one second
delay between each digit. The library code 1 2 1 3 would blink the
status LED.
Flash [Delay] Flash Flash [Delay] Flash [Delay] Flash Flash Flash
Factory Reset
The Universal Projector Remote Control can be reset to factory
default. All user programmed codes and learned codes will be
erased.
• Press and hold both the
Up and Down arrows simultaneously for
3 seconds.
• The status LED will turn off while both keys are pressed but will
turn solid red after three seconds.
• Press the
Off key
• Wait one second then press the
Reset key.
Factory default settings will be set and LED will go OFF to indicate a
successful factory reset.