Searching for a code – SMK-Link Electronics Universal Projector Remote Control User Manual
Page 8
Page 6
– On the other remote control, press and hold the key you wish
the Universal Projector Remote to learn.
– If learning was successful, the status LED will flash once.
If learning was unsuccessful, the status LED will flash three
times.
• Once you are done customizing, wait 30 seconds to exit learning
mode.
Searching For A Code
If you have tried all of the codes for your projector and are unable
to find a match, you can also search the entire database quickly for a
compatible code.
• Turn the projector on and wait for it to warm up.
• Press and hold both the
Up and Down arrows simultaneously for
3 seconds.
• The status LED will turn off while both keys are pressed but will
turn solid red after three seconds.
• Press the
Menu key to enter Automatic Code Search
mode. The LED will blink off one second and turn on
again.
Menu