Setting your projector, Entering library codes – SMK-Link Electronics Universal Projector Remote Control User Manual

Page 6

Advertising
background image

Page 4

Setting your Projector

Entering Library Codes

To test a four-digit code to see if it controls your projector, please

complete the following steps. Available codes are listed in the

Appendix. Some brands have multiple codes which work for

different models.

• Press and hold both the

Up and Down arrows

simultaneously for 3 seconds.

• The status LED will turn off while both keys are

pressed but will turn solid red after three seconds.

• As you enter each digit of the code, the status light

will briefly turn off. Do not enter the next digit until

the status light is on.

After entering the code, the status light will go off. Taking longer

than 30 seconds, pressing any other key or entering an invalid code

will cause the status light to blink quickly three times.

Test your library choice to make sure it is working. If it is not working,

try the next code. Not all keys will be supported for all models.

Unused keys can be customized or ignored.

Advertising