Learning from another remote – SMK-Link Electronics Universal Projector Remote Control User Manual
Page 7
Advertising
Page 5
Learning From Another Remote
If you have access to the original remote control for your projector
or wish to learn from other remote controls, place the two remote
controls end pointing towards one another approximately two to
three inches apart.
• To enter learning mode, press and hold both the
Left and Right
arrows simultaneously for 3 seconds. The status LED will turn
off while both keys are pressed but will turn solid red after three
seconds.
• Repeat the following steps until you are done customizing.
– Tap the key you wish to customize on your Universal Projector
Remote. The status LED will flash.
O
ff
Power
Input
Input
Status
4
3
2
1
Advertising