BayTech DS2-RPC 2012 - Manual (Page 13)

Page
13
Enable/Disable Confirmation
Enable/Disable Status Menu
DS2­RPC Receptacle Controls
On, Off, Reboot
Current Outlet: Outlet 4
Modify (Y/N)? Y
Enter: If the unit displays the following: Type “Y” for yes to change the outlet
name and type the new name.
Type “N” to keep the same outlet name.
Select 3), to enable or disable the confirmation option.
If the enable/disable feature is disabled, the DS will not ask to confirm
the command.
From the configuration menu, select “Enable/Disable Confirmation.”
Depending on the current status of the switch, the DS responds with the
option to change the current status. Default is Enabled. Disable Confirmation (Y/N)? Y
Select 4), to enable or disable the status menu. The DS displays the
following:
If the Enable/Disable Status Menu feature is disabled, only the DS>
prompt appears, else the following status menu appears.
Default is Enabled.
Disable Status Menu (Y/N)? Y
On, Off, Reboot, Lock, and Unlock are commands to control the
individual outlets. From the (DS-RPC >) prompt, enter one of the
following commands: {ON n}, {OFF n}, {REBOOT n}, where “n” is the
outlet number you want to command.
Example: To turn ‘On’ Outlet 3, type “ON 3” from the DS-RPC prompt.
The DS responds with: Circuit Breaker: On
1)...Outlet 1 : On
2)...Outlet 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On
DS-RPC>
Turn On Outlet 3 (Y/N)?
Type “Y” for yes turns ‘On’ Outlet 3. Observe the status of Outlet 3 has changed to ‘On’ in the status
menu. Likewise, typing ‘ON ALL’, ‘ON 0’, or ‘ON’ at the DS-RPC > prompt and responding “Y” for
yes, turns ‘On’ all outlets. The {OFF n} command work similarly as the {ON n} command.
The {REBOOT n} command will reboot or reset equipment attached to corresponding receptacle(s).
When the command to REBOOT is sent from the DS-RPC > prompt, the DS powers ‘Off’ the
corresponding outlet(s) for approximately 10 seconds, then powers them ‘On’ in sequence.
This command only works on outlets which were ‘On’ prior to receiving the reboot command
NOTE: Type the Attention Character, Default: semi-colon (;), 5-times quickly, to get out of the DS-RPC
module.