BayTech DS2-RPC 2012 - Manual (Page 22)

Page
22
Clear
Voltage
Temp
Logging Out
Current User Password:
Identify Current User
Unit Identification
Type “unitid” at the prompt to determine the Unit ID, the MRP displays the
following:
To change the unit ID, go the Outlet Configuration menu and select ‘Change Unit
ID’ option. The maximum field length is 32 or 16 for older units.
Type “Whoami” at the prompt to determine the current user, the unit displays the
following:
To change the user, logout of the unit and log back in using the new user name.
Current User: root
Type “Password” at the prompt to change the current user’s password
and the unit will display the following:
Enter new Password:
Re-Enter new Password:
If the current user already has a password the unit will display the
following: Enter old Password:
Enter new Password:
Re-Enter new Password:
NOTE: If you do not have the user’s current password, delete the user. Reinstall user. Select
option to change password and the unit will respond asking for a new password
Type “Logout”, “Logoff”, or “Exit” at the prompt to logoff from the unit. This will close the Outlet
Control session. Press “Enter” to open the Outlet Controller session. A login prompt may appear if a user
has been assign to an outlet. Newer firmware may go to the network menu.
Type “Voltage” at the prompt to display the unit’s True RMS
Voltage, and the unit will display the following.
Type “Temp” at the prompt to show the unit’s current
temperature, the units will display the following:
Internal Temperature: 33.5 C
Unit ID: DS4-RPC
Type “Clear” at the prompt to reset the Maximum Detected, the unit will redisplay the status menu with
the new maximum detected current. Admin user only
True RMS Voltage: 122.2 Volts