BayTech DS2-RPC 2012 - Manual (Page 20)

Page
20
DS4(A)­RPC OUTLET CONTROL
Device A ................1
Device B ................2
Device C ................3
Device D ................4
DS-RPC ................5
Configure.......................C
Status..........................S
Unit Reset......................RU
Logout..........................T
Enter Request: 5 From the Host Module Menu, Select the number
corresponding to the DS-RPC, in this screen shot the
number is “5”.
The DS-RPC module displays the following menu below.
Outlet Default is ON.
DS-RPC Series
(C) 2001 by BayTech
F2.05
Option(s) Installed:
True RMS Current
Internal Temperature
True RMS Voltage
Unit ID: Site Alpha
Average Power: 0 Watts Apparent Power: 26 VA
True RMS Voltage: 120.5 Volts
True RMS Current: 0.1 Amps Maximum Detected: 0.2 Amps
Internal Temperature: 29.5 C
Outlet Circuit Breaker: Good
1)...Tester 1 : On
2)...Outlet 2 : On
3)...Outlet 3 : On
4)...Outlet 4 : On
Type "Help" for a list of commands
DS-RPC>help
Type “Help” at the prompt for a list of
Outlet Controller commands
NOTE: Only the Admin user will
have the {Config}, {Lock n},
{Unlock n}, or {Clear} options
available.
On n <cr> --Turn on an Outlet, n=0,1...4,all
Off n <cr> --Turn off an Outlet, n=0,1...4,all
Reboot n <cr> --Reboot an Outlet, n=0,1...4,all
Status <cr> --DS-RPC Status
Config <cr> --Enter configuration mode
Lock n <cr> --Locks Outlet(s) state, n=0,1...4,all
Unlock n <cr> --Unlock Outlet(s) state, n=0,1...4,all
Current <cr> --Display True RMS Current
Clear <cr> --Reset the maximum detected current
Temp <cr> --Read current temperature
Voltage <cr> --Display True RMS Voltage
Logout <cr> --Logoff
Logoff <cr> --Logoff
Exit <cr> --Logoff
Password <cr> --Changes the current user password
Whoami <cr> --Displays the current user name
Unitid <cr> --Displays the unit ID
Help <cr> --This Command
Type "Help" for a list of commands
DS-RPC>