Contemporary Control Systems Compact Managed Switches Software Manual for Console Access - Manual (Page 36)

TD020850-0MG
36
4.3.8.3 Display Faults
Figure 30 depicts an 8-port switch example of a Display Faults report. For switches of
16- and 24-ports, the applicable number of ports would be displayed. Except for the
refresh option, this screen is read-only. The current fault report is displayed when the
screen first appears. While on screen, this report is static; it will only be updated if the
refresh option is selected.
Figure 30 — Display Faults
After relay activation is noted, the fault should be corrected. If No Link monitoring is in
force, this will require restoration of a broken link or repair of the defective device to
which the switch is connected. On the other hand, if Link Present monitoring is in use,
removing the offending cable or end device will be required.