Contemporary Control Systems Compact Managed Switches Software Manual for Console Access - Manual (Page 53)

TD020850-0MG
53
4.4.3 Configure SNMP Trap Receivers
An SNMP Trap is a message that is transmitted when a trap event occurs. The menu in
Figure 44 allows up to four trap receivers and each must be marked Valid for it to be
used. Each valid trap receiver will receive a trap message upon a trap event occurring.
The switch supports traps for :
link-up
link-down
authentication failure
cold start
warm start
The example of Figure 44 defines an IP Address for only one trap receiver — which will
function because its status parameter has been toggled to Valid.
Figure 44 — Configure SNMP Trap Receivers