Gasboy M04230K00X - Manual (Page 22)

Installing the Pulser Kit in Twin Unit
Page 22 MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005
4 Move the computer in place aligning the mounting holes and ensuring that the two shafts are
properly seated (as noted prior to moving the computers).
5 Secure the computer in place with the mounting bolts saved during the initial moving
procedure.
Installing the Remaining Conduit
1 In the kit, locate the following parts:
• four 066400 conduit unions
• one 064830 conduit tee
• one 025045 conduit elbow
• one 023946 conduit - bent pulser twin
Note: Feed wires through conduit and fittings as it is assembled.
2 Install a 066400 conduit union on the 023945 conduit and 023944 conduit (mounted to the
pulser and coupling assemblies).
3 Install the 023946 conduit on the 064830 conduit tee (orient as shown in figure above).
4 Install the 025045 conduit elbow on the 023946 conduit (on end with bend near the end).
5 Install the 064830 conduit tee/023946 conduit assembly on the two unions installed in step 2.
6 Install a 066400 union on the M025045 conduit elbow
7 Install conduit/elbow/union assembly between tee and junction box. Be sure the wires are
extending into junction box.
Conduit from Pulsers
064830 Conduit
Tee
066400 Unions
025045 elbow
023946 conduit