Gasboy M04230K00X - Manual (Page 24)

Installing the Pulser Kit in Single Unit
Page 24 MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005
Installing the Pulser Kit in Single Unit
Preparation
1 Request permission from the manager/owner to remove power from the unit and then remove
power using normal procedures. Observe the lockout/tagout safety procedures.
2 Using the proper key for the unit, unlock and remove the doors from both sides of the unit.
Place doors in a safe place to prevent damage or scratches.
3 On both sides of the unit, remove the two screws securing the bezel and remove the bezel.
Store bezels and screws in a safe place for reuse.
4 Remove the screws securing the dial face in place and remove the dial faces from both sides
the computer. Store dial faces and screws in a safe place to prevent damage or scratches.
5 Make sure you have the proper kit for the model dispenser to be retrofitted.
Installing Drive Gear on Meter Computer Shaft
In the kit, locate a 043225 pin, a 031035 hub, a 027401 gear, and a 049406 retaining ring.
1 On the computer, press a pin into the hole in the computer shaft until it is flush on one side of
the shaft.
2 Place a hub on the shaft with the slotted portion of hub straddling the extending pin and align
hole in the hub with pin.
3 Push the pin through the hole in the hub until the pin is extending equally on both sides of the
hub.
4 Place a gear on the hub and align pin in the shaft with bearing slot in gear.
5 Secure gear in place by placing a retaining ring in the slot near the end of the shaft.
Retaining Ring
Hub
Pin
Computer
Shaft