Gasboy M04230K00X - Manual (Page 25)

MDE-4282B Gasboy Pulser Kits M04230K00X Installation • July 2005 Page 25
Installing the Pulser Kit in Single Unit
Installing Plate and Idler Assembly
1 In the kit, locate the 053920 screw and the 027044 Plate and Idler Assembly.
Note: The 053920 mounting screw for the Plate and Idler Assembly is a self-tapping screw.
Turning the screw into the mounting hole in the computer side frame and then removing
it without the assembly in place will make mounting the assembly easier.
2 Hold the Plate and Idler Gear Assembly in place and loosely secure with the mounting screw.
Boss and bracket hole in the computer align assembly for proper gear meshing.
Note: This illustration is shown rotated 90 degrees from its installed position.
3 Ensure proper gear position, alignment, and meshing and tighten mounting screw.
Assembling 046970 Pulser Mounting Plate and 046973 (10:1) or 046972
(100:1) Pulser and Coupling Assembly
1 In the kit, locate a 046970 mounting plate, a 0469XX* Pulser and Coupling Assembly, three
051805 screws, and three 068891 lock washers.
*The part number depends on which kit is being installed - 046973 for 10:1, 046972 for 100:1
2 Place the mounting plate on the Pulser and Coupling Assembly, align the three mounting
holes, and loosely secure with three screws and three lock washers.
3 Tighten all screws equally.
Mounting
Screw
Plate and Idler
Gear Assembly
Excessive tightening of mounting screw will crack the plastic plate .
CAUTION