Geist R-Series PDU v4 - Manual (Page 25)

Web Interface 25
© 2014 Geist
Time To Action describes the time left before the pending action will take
place. This is adjusted using Delays.
3. Select the operation you wish to perform:
On/Off turns on/off the selected outlet.
For an outlet currently on, Reboot cycles the outlet off, then back on after the
reboot hold delay. For an outlet currently off, Reboot turns the outlet on.
Cancel will cancel the current operation if it has not been completed yet.
Reset kW Hours will reset the total Energy measured in kWh for the selected
outlet.
4. For operations involving the state of the outlet, setting Delay to True will use the
current Delay configuration for each outlet when performing the selected
operation. Delays are configured in "Outlet Configuration".
5. Select Submit to issue the action.
4.1.2 Alarms & Warnings
The Alarms & Warnings page allows users to establish alarm or warning conditions
(hereafter referred to as "Events") for each power and circuit readings. Events are
triggered when a measurement exceeds a user-defined threshold, either going above
the threshold ("high-trip") or below it ("low-trip"). Events are displayed in different
sections, based on the device or measurement the Event is associated with. Each
Event can have one or more Actions to be taken when the Event occurs.
1. State: Shows the status of each Event.
Empty: No alert condition.
: This symbol indicates that this particular "Warning" Event has been
tripped. A tripped Warning Event displays in orange.
: This symbol indicates that this particular "Alarm" Event has been tripped.
A tripped Alarm Event displays in red.
: This symbol will indicate that this Event has been acknowledged by user
after being tripped. It will remain this way until the condition being measured by
this Event returns to normal (i.e. ceases to exceed the trigger threshold for this
Event.)