Geist R-Series PDU v4 - Manual (Page 38)

R-Series PDU v4 Instruction Manual 38
© 2014 Geist
To Add or Modify a Target Email address:
1. Click on the Add or Modify icon.
2. Type email address and then click Save.
To Delete a Target Email address:
1. Click on the Delete icon next to the address to delete.
2. Click the Delete button on the pop-up window to confirm.
To send a test e-mail:
1. Click on the Test Email icon next to the address to test.
2. A pop-up window will indicate that the test e-mail is being sent. Click OK to
dismiss the pop-up.
4.2.4 SNMP
Simple Network Management Protocol (SNMP) can be used to monitor the unit's
measurements and status, if desired. SNMP v1, v2c and v3 are supported. In
addition, alarm traps can be sent to up to two IP addresses.
The SNMP Service can be enabled or disabled. The service will listen for data-read
requests (a.k.a. "Get requests") on Port 161, which is the usual default for SNMP
services; this can also be changed if desired.
The MIB is can be downloaded from the unit, via the link at the top of the page.
Clicking this link will download a .ZIP archive containing both the MIB file and a CSV-
formatted spreadsheet describing the available OIDs in a readable form to assist in
setting up a SNMP manager.