Removing the power supply unit – VXL Instruments Itona TC72yy Series User Manual
Page 17
Advertising
13
Removing the Power Supply Unit
7
Removing the Power Supply Unit
To replace the power supply unit:
1. Disconnect the ATX power supply cable as shown in the Figure 13.
Figure 13: ATX Power Supply
2. Using the star screwdriver ( Item B in Figure 1), unscrew the three screws holding the power
supply unit as shown in Figure 14: AC
Figure 14: AC Power Unit Screws
Note: Do not remove the earth connection (The green yellow wire).
3. Remove the power supply unit outward as shown in Figure 15
Advertising
This manual is related to the following products: