H3C Technologies H3C S10500 Series Switches - Manual (Page 67)

56
MPLS configuration task list
Complete the following tasks to configure MPLS:
Task Remarks
Enabling the MPLS function Required
Configuring a static LSP Required
Configuring MPLS LDP capability Required
Configuring local LDP session
parameters
Optional
Configuring remote LDP session
parameters
Optional
Configuring PHP Optional
Configuring the policy for triggering
LSP establishment
Optional
Configuring the label distribution
control mode
Optional
Configuring LDP loop detection Optional
Configuring LDP MD5 authentication Optional
Establishing dynamic LSPs
through LDP
Configuring LDP label filtering Optional
Use either the static
or dynamic LSP
configuration
method
Configuring BFD for MPLS LDP Optional
Maintaining LDP sessions
Resetting LDP sessions Optional
Configuring TTL processing mode at
ingress
Optional
Sending back ICMP TTL exceeded
messages for MPLS TTL expired
packets
Optional
Managing and optimizing MPLS
forwarding
Configuring LDP GR Optional
Configuring MPLS statistics
collection and reading Setting MPLS statistics reading
interval
Optional
Configuring MPLS LSP ping Optional
Configuring MPLS LSP tracert Optional
Configuring BFD for LSPs Optional
Inspecting LSPs
Configuring periodic LSP tracert Optional
Enabling MPLS trap Optional
NOTE:
These types of interfaces support MPLS capability: Layer 3 Ethernet interface, Layer 3 aggregate interface
and VLAN interface.