H3C Technologies H3C S5560 Series Switches - Manual (Page 179)

163
Task Command
Clear the data structure information of an
IS-IS neighbor.
reset isis peer system-id [ process-id ]
Clear OSI connection statistics. reset osi statistics
IS-IS configuration examples
Basic IS-IS configuration example
Network requirements
As shown in Figure 40 , Switch A, Switch B, Switch C, and Switch D reside in an IS-IS AS.
Switch A and B are Level-1 switches, Switch D is a Level-2 switch, and Switch C is a Level-1-2 switch. Switch
A, Switch B, and Switch C are in Area 10, and Switch D is in Area 20.
Figure 40 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure IS-IS:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] is-level level-1
[SwitchA-isis-1] network-entity 10.0000.0000.0001.00
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] isis enable 1
[SwitchA-Vlan-interface100] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] isis 1
[SwitchB-isis-1] is-level level-1