H3C Technologies H3C S5560 Series Switches - Manual (Page 371)

355
Task Command
Display configuration information for a
RIPng process.
display ripng [ process-id ]
Display routes in the RIPng database. display ripng process-id database [ ipv6-address prefix-length ]
Display routing information for a RIPng
process. display ripng process-id route [ ipv6-address prefix-length
[ verbose ] | peer ipv6-address | statistics ]
Display RIPng interface information.
display ripng process-id interface [ interface-type
interface-number ]
Reset a RIPng process. reset ripng process-id process
Clear statistics for a RIPng process. reset ripng process-id statistics
RIPng configuration examples
Basic RIPng configuration example
Network requirements
As shown in Figure 85 , Switch A, Switch B, and Switch C run RIPng. Configure Switch B to filter the route
2::/64 learned from Switch A and to forward only the route 4::/64 to Switch A.
Figure 85 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 400
[SwitchA-Vlan-interface400] ripng 1 enable
[SwitchA-Vlan-interface400] quit
# Configure Switch B.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit