H3C Technologies H3C S5560 Series Switches - Manual (Page 455)

439
• If you configure the following apply clauses on all the nodes, the apply clause of each node takes
effect:
{
apply as-path without the replace keyword.
{
apply cost with the + or – keyword.
{
apply community with the additive keyword.
{
apply extcommunity with the additive keyword.
• The apply comm-list delete clause configured on the current node cannot delete the community
attributes set by the apply community clauses of the preceding nodes.
To configure the continue clause:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter routing policy node view. route-policy route-policy-name
{ deny | permit } node node-number N/A
3. Specify the next node to be
matched.
continue [ node-number ]
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.
Displaying and maintaining the routing policy
Execute display commands in any view and reset commands in user view.
Task Command
Display BGP AS path list information. display ip as-path [ as-path-number ]
Display BGP community list information.
display ip community-list [ basic-community-list-number |
adv-community-list-number | name comm-list-name ]
Display BGP extended community list
information.
display ip extcommunity-list [ ext-comm-list-number ]
Display IPv4 prefix list statistics. display ip prefix-list [ name prefix-list-name ]
Display IPv6 prefix list statistics. display ipv6 prefix-list [ name prefix-list-name ]
Display routing policy information. display route-policy [ name route-policy-name ]
Clear IPv4 prefix list statistics. reset ip prefix-list [ prefix-list-name ]
Clear IPv6 prefix list statistics. reset ipv6 prefix-list [ prefix-list-name ]