Grass Valley FT Server - Manual (Page 17)

Install rack rail brackets in IT rack
The FT server chassis requires 4RU of space. Be sure to have another person help you to install the
chassis, do not attempt to install it alone.
You will need the following hardware from the accessory kit to install the rack rail brackets to
support the chassis in an EIA IT rack:
• 2 rack rail mounting brackets
• 4 washers for panhead screws
• 8 plate screws
• 8 panhead screws
• 4 core nuts (not provided)
1. Determine where in the rack you want to install the FT server chassis. If using an empty rack,
install it in a lower position near the bottom of the rack rather than at the top to maintain balance.
2. Next to a square hole on the rack, an imprinted mark indicates 1RU. This device is 4RU (about
176 mm), so install it between the imprinted marks that indicate the height of 4RU.
3. If the rack has front and rear doors, read the instruction that comes with the rack, and open them.
20131220 FT Server Instruction Manual 17
FT Server Installation Information