HEIDENHAIN ND 720 v.3 - Manual (Page 63)

63
Line 4
Output of axis causing the error
X F C T . X = 0 <CR> <LF>
13 characters 3 ch. 6 characters 2 characters
Axis causing the error Sep. block Axis value End
Left-aligned Right-aligned
Line 5
Output of spacing between compensation points
S P A C I N G X = 1 4 <CR> <LF>
13 characters 3 ch. 6 characters 2 characters
Spacing left-aligned Sep. block Spacing End
Right-aligned
Line 6
Output of datum point for compensation
D A T U M X = + 0 . 0 0 0 <CR> <LF>
13 characters 3 ch. 13 characters 2 characters
Datum left-aligned Sep. block Datum value right-aligned End
Line 7
Output of compensation value no. 0
X N R . 0 0 = + 0 . 0 0 0 <CR> <LF>
13 characters 3 ch. 13 characters 2 characters
Compensation value no. left-aligned Sep. block Compensation value right-aligned End
Output
S
tructure
of
C
ompensation-Value
Table
Bateil2.pm6 27.03.2002, 12:09 63