HEIDENHAIN ND 720 v.3 User Manual
Page 64
64
Subsequent lines: Output of compensation values 1 - 63
Output of compensation values
X N R . 6 3 = + 0 . 1 2 3 <CR> <LF>
13 characters 3 ch. 13 characters 2 characters
Compensation value no. left-aligned Sep. block Compensation value right-aligned End
Last line:
Each compensation-value table ends with the final character <*> (HEX: 0x2A)
* <CR> <LF>
3 characters
Output
S
tructure
of
C
ompensation-Value
Table
Compensation-value table ND 720, X axis
Compensation-value table
Description
*
Starting character (*);
ND-720
MM
Type of display unit; unit of measure (MM or IN);
AXIS X
= 0
Axis to be corrected, X = 0; Y = 1; Z = 2;
X FCT. X
= 0
Axis causing the error, X = 0; Y = 1; Z = 2;
SPACING X
= 14
Spacing (Range : 6 23)
DATUM X
=
+ 0.000
Datum point 0 mm (value input)
X
NR. 00
=
+ 0.000
Compensation value 0 = 0.000 mm (compensation value 0 is always 0)
X
NR. 01
=
----------
Compensation value 1 = no value entered
X
NR. 02
=
----------
Compensation values 2 63: no value entered (axis is not corrected)
X
NR. 03
=
----------
.
.
Bateil2.pm6
27.03.2002, 12:09
64