HEIDENHAIN PT 855 for Milling - Manual (Page 64)

I - 4 Programming POSITIP
62 Operating Instructions POSITIP 855
Cycle
5.0 RECTANGULAR POCKET
is then run in the
EXECUTE PRO-
GRAM
operating mode (see Chapter I-5).
Program blocks
0 BEGIN PGM 55 MM
Start of program, program number, unit of measurement
1 CYCL 5.0 RECT. POCKET
Cycle data for cycle 5.0 RECTANGULAR POCKET
2 CYCL 5.1 START 2
Starting position above the workpiece surface
3 CYCL 5.2 DEPTH – 20
Milling depth
4 CYCL 5.3 POSX + 50
Pocket center in X
5 CYCL 5.4 POSY + 40
Pocket center in Y
6 CYCL 5.5 LGTHX 80
Side length in X
7 CYCL 5.6 LGTHY 60
Side length in Y
8 CYCL 5.7 DIR. 0 :CLIMB
Climb milling
9 CYCL 5.8 FIN.AL 0.5
Finishing allowance
10 END PGM 55 MM
End of program, program number, unit of measurement
Rectangular pocket milling in programs