MCZ Tube 2013 - Manual (Page 38)

D
E
ON
OFF
G
D
36
8-EMERGENCY PANEL
EMERGENCY PANEL START-UP/SHUTDOWN
If the remote control is faulty or the batteries are flat, the product can be operated in safe mode via the rear emergency panel.
In this configuration, the product can only work in manual mode and one of 3 power levels can be selected.
• APPLIANCE START-UP WITHOUT THE REMOTE CONTROL.
Switch the product on by bringing selector “D” to the ON position. The RED LED goes off upon start-up, whereas the GREEN LED starts
to flash until the start-up phase is complete. Once the product runs smoothly, the GREEN LED remains on.
• SELECTING THE POWER WITHOUT THE REMOTE CONTROL.
One of three heating powers MIN-MED-MAX can be selected (selector “E”):
The MINIMUM power corresponds to the 1st power.
The MEDIUM power corresponds to the 3rd power.
The MAXIMUM power corresponds to the 5th power.
• APPLIANCE SHUTDOWN WITHOUT THE REMOTE CONTROL.
Switch the product off by bringing selector “D” to the OFF position.
Once the remote control is restored, remember to set selector “D” back to the “REMOTE” position, otherwise the
product will ignore the remote control commands.
REMOTE CONTROL SYNCHRONIZATION
When the product is started up for the first time, it may be necessary to synchronize the new remote control with the stove. To do this,
follow these simple instructions:
• connect the socket to the stove and turn on the power switch
• make sure the selector D on the emergency panel is in the REMOTE position
• when the first message appears on the emergency panel's display, use a pointed object to press the chased G button (toothpick, etc.)
• the panel's display will show 3 flashing lines “---“. Press the remote control's on/off button to launch the learning process.
The three flashing lines will disappear from the display and the stove will learn the remote control's new communication address. The
learning process is also confirmed by 4 audio signals.
REMOTE CONTROL SYNCHRONIZATION
SWITCH-ON/OFF FROM THE EMERGENCY PANEL