MCZ Tube 2013 - Manual (Page 44)

42
10-MAINTENANCE AND CLEANING
EXAMPLE OF A CLEAN BRAZIER EXAMPLE OF A DIRTY BRAZIER
ATTENTION!
All the cleaning operations of all parts must be performed with a completely cold product and the plug disconnected.
The product requires little maintenance if used with certified good quality pellets.
DAILY OR WEEKLY CLEANING PERFORMED BY THE USER
Before each start-up
Clean the ash and any deposits in the brazier that could clog the air passage holes.
If the pellets in the hopper finish, unburned pellets may accumulate in the brazier. Always empty the residue in the brazier before
starting-up.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE START-UP AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT.
For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the
bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the
component.
CHECK EVERY 2/3 DAYS
Clean and empty the ash pan, being careful of hot ashes.
Only if the ash is completely cold can a vacuum cleaner be used to remove it. In this case, use an adequate vacuum cleaner to remove
particles that are not so small. Experience and the quality of the pellets will determine the cleaning frequency required. However, it is
recommended not to exceed 2 or 3 days.
CLEANING THE GLASS
It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specific detergent and clean with a cloth.
ATTENTION!
Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets
(ceramic fibre cord).