9 installing an ns115 module, 9installing an ns115 module, Mounting of the ns115 module – Yaskawa AC Servo Drives Sigma II Series User Manual

Page 10

Advertising
background image

E-8

9

INSTALLING AN NS115 Module

This section describes the methods and the installation sites for mounting an NS115 Module on
a SERVOPACK.

„

Mounting of the NS115 Module

Mount an NS115 Module on a SGDH SERVOPACK in the following manner.

1. Remove the connector cover mounted on the CN10 of the SERVOPACK.

Mounting

Method

SERVOPACK Type

Screw

Remarks

Base
mounted

SGDH-A3 to 02BE
SGDH-A3 to 10AE

M3

×

10 round head screws

(with spring washer and
plain washer)

Use attached screws on the NS115 Module.

SGDH-15 to 50AE
SGDH-05 to 50DE

M4

×

10 round head screws

(with spring washer and
plain washer)

Use attached screws on the NS115 Module.

SGDH-60 to 1EAE
SGDH-60 to 1EDE

M4

×

8 round head screws

(with spring washer and
plain washer)

Use the screw of the front panel.

Rack
mounted

SGDH-A3 to 02BE-R
SGDH-A3 to 50AE-R
SGDH-05 to 50DE-R

M4

×

6 round head screws

(with spring washer and
plain washer)

Use attached screws on the NS115 Module.
Note: Make sure that spring washers and
plain washers are used for mounting.
(Otherwise, the screw for connecting
ground wire sticks out from the other
side of the flange, and the SERVO-
PACK cannot be mounted properly.)

Duct
ventilated

SGDH-60 to 1EAE-P
SGDH-60 to 1EDE-P

M4

×

8 round head screws

(with spring washer and
plain washer)

Use the screw of the front panel.

MODE/SET

DATA/

CHARGE

POWER

SGDH-

SERVOPACK

YASKAWA

CN10

SERVOPACK

Connector
cover

Advertising
This manual is related to the following products: