Honeywell HC900 - Manual (Page 69)

Revision 10 HC900 Hybrid Controller Communications User Guide 61
12/07
Fixed
Address
(hex) Fixed
Register
(decimal) Parameter Access Notes
1F10 7953 Jog Segment R/W Floating Point
Writing to this register is only permissible in
the reset or ready mode
1F12 7955 Loop Start R/W Floating Point
0 indicates no loop.
Writing to this register is only permissible in
the reset or ready mode
1F14 7957 Loop End R/W Floating Point
0 indicates no loop.
Writing to this register is only permissible in
the reset or ready mode
1F16 7959 Repeats R/W Floating Point
0 indicates loop forever.
Writing to this register is only permissible in
the reset or ready mode
1F3A 7995 Time Units** R/W Bit Packed
Bit 0:
Reserved
1: minutes
2: hours
3-15: Unused
1F3B 7996 Ramp Units** R/W Bit Packed
Bit
0: 0:Time; 1:Rate
Bit 1-15: Unused
Writing to this register is only permissible in
the reset or ready mode
1F3C 7997 Guaranteed Soak Type ** R/W Bit Packed
For selection of Soak (or Hold) guarantee –
Per Segment (requiring selection per
segment in a table)
Bit
0: per segment
1: all soaks
2: all segments
3-15: Unused
None if none of the bits is set
Writing to this register is only permissible in
the reset or ready mode