Marantz PMD671 - Manual (Page 13)

- 13 -
SOLID STATE RECORDER PMD671
POWER
MIC ATTEN
0dB -20dB
FLAT
ANC
LEVEL CONT.
LIMITER ALC MANUAL OFF ON
EDL PLAY
STEREO L
AUDIO OUT
R SOURCE FILE
MONITOR OFF ON
PRE REC
MARK A-B REPEAT INPUT
EDIT
SINGLE OFF ALL
OFF ON
INPUT LOCK
TRACK JUMP
MARGIN RESET
REC UNDO
MENU/STORE ENTER CANCEL
PLAY / PAUSE STOP
USB
- / REW FWD / +
1 2
POWER
-dB
00 40 20 12 6 2 0 over -dB
R
L
L
R
-dB over 0 2 6 12 20 40 00
-dB
• There are four ways to power the PMD671:
• Included AC adapter
• AA Alkaline batteries (~ 5 hours @ 1450 mAh
usage)
• Optional rechargeable Ni-Cd battery pack
RB1100 (~ 4 hours @1100 mAh usage).
• Optional rechargeable Ni-MH battery
RB1651 (~ 6 hours @1650 mAh usage).
• Built-in Time and Date generator marks the
beginning of each track.
• REMOTE1 jack permits a wired remote button
for controlling the recording process.
• REMOTE2 jack permits using the optional
RC600 remote for microphone interviews.
Controls and Connections
Top
1. Speaker
The played back audio signal is simulta-
neously output to the built-in speaker, the
PHONES jack, LINE OUT jacks and DIGITAL
OUT jack. Headphones plugged into the
PHONES jack mute the internal speaker. The
HP/SPK VOLUME control controls the built-
in Speaker and Headphone volume.
2. MIC (internal microphone)
3. POWER switch
Slide to the right and release
to turn Power on or off.
If the AC power pack is
connected at DC IN and plugged in, it powers the
PMD671.
If power is not detected at DC IN, battery power is
automatically used if available.
Loading is displayed,
then the screen goes
blank momentarily.
Reading is displayed
while the CF card is
read.
ALL OFF
SINGLE
R
AUDIO OUT
L
STEREO
FLAT
-20dB 0dB
MIC ATTEN
REPEAT
EDL PLAY
ON OFF MANUAL ALC
LIMITER
LEVEL CONT.
ANC
INPUT LOCK
ON OFF
PRE REC
ON OFF
MONITOR
FILE SOURCE
EDIT
INPUT A-B REPEAT MARK
5
MONITOR
FILE SOURCE
When first powered up, the PMD671 takes some
time to initialize.
3 4
Security cover
Use a small Phillips screw-
driver to remove or replace
the Security cover.
The Security cover makes
setup controls relatively unavailable. The setup
controls allow you to setup the PMD671 for your
unique application. You can then have someone
operate the PMD671 without concern that they
might change something that could cause failure
to record.
Note: Two 3mm machine screws
10mm long are used for the
security cover.
Recording setup controls
5. MONITOR switch
This switch turns the Read
After Write or Time Shift
Playback* feature on or off.
*Depending on the setting of RAW mode in the Menu.
When RAW Mode is at MONITOR, and the
MONITOR switch is at FILE when recording
begins, Read After Write is on.
When RAW Mode is at TimeShft, and the MONI-
TOR switch is at FILE when recording begins,
the Time Shift feature is on.
continues