Marantz PMD671 - Manual (Page 44)

- 44 -
Remote Mode (REMOTE1 jack only)
Use a wired remote (not supplied) to control the
PMD671. There are five remote modes:
• StartPause – during recording or playback,
switch off to pause and on to resume (record-
ing on the same track).
• StrtStp TR - during recording, switch off to
pause recording and on to start recording a
new track.
• EDL Mark – during recording, switch remote
to on to add an EDL mark.
• PWR REC – during power off, switch remote
on to turn power on and begin recording.
During recording, switch remote off to stop
recording and power off.
• Manual TRK – during recording, switch
remote on to increment the track. Recording
continues with a new track created at that
point.
Default is StartPause.
How to set or change the Remote Mode
Quick instructions
Press & hold
MENU/STORE 2 sec ....... Preset
Double Click ENTER .................. RecFormat
Press F.FWD/+ until ......................... Remote
Press ENTER ........... StartPause/StrtStp TR/
............... EDL Mark/PWR REC/Manual TRK
Press F.FWD/+ ............... tab Remote Modes
Press ENTER ................................... Remote
Press MENU/STORE .................... store & exit
repeatedly until
Remote is dis-
played and
flashing.
accept the
Remote choice
and switch to
RemoteMode choices.
4. Press and release the F.FWD/+ button or
the -/F.REV
button
to tab
through the
RemoteMode choices: StartPause, StartStp
TR, EDL Mark, PWR REC, or Manual TRK.
5. When correct,
press and release
the ENTER
button to switch to RemoteMode flashing.
You can:
•
Press and release the F.FWD/+ button or the -/
F.REV button to tab to another menu choice, or
• Press and release the MENU/STORE button to write
the menu changes and return to stop mode, or
• Press and release the CANCEL button to cancel all
menu changes and return to stop mode.
Broadcast Wave ID numbers
Broadcast Wave Format (.bwf) has three identifi-
cation numbers in the header (Extension Chunk):
Description, Originator, and Originator Reference.
For example, if the IDs are used for a broadcast
station ID1 could be the identifier of the station,
ID2 could be used for the department code, and
ID3 for the badge number of the reporter.
Default is all ID numbers at 000000.
How to set or change ID numbers
Quick instructions
Press & hold
MENU/STORE 2 sec ....... Preset
Double Click ENTER .................. RecFormat
Press F.FWD/+ until ..................... ID1Dscrpt
................................. ID2Origin or ID3OrgRef
Press ENTER ..................... 1st digit flashing
a Press F.FWD/+ .............................. tab 0-9
b Press ENTER ................. save & next digit
Repeat a, b until ................................ 6th digit set
Press ENTER
............................... ID1Dscrpt
................................. ID2Origin or ID3OrgRef
Press MENU/STORE .................... store & exit
1. Select the RemoteMode menu choice:
a. From stop, press and hold the MENU
button for about 2 seconds. Preset will appear
b. While Preset is flashing, double click the
ENTER button .
The last Menu
choice selected
will appear.
2. Press and release the F.FWD/+ button
3. Press and release the ENTER button to
(flashing) in the
display.