Invacare LYNX PANTHER LX-4 - Manual (Page 46)

46 46
PROCEDURE 10 REPLACEMENT PARTS - PANTHER LX - 4
R
E
P
L
A
C
E
M
E
N
T
P
A
R
T
S
P
A
N
T
H
E
R
L
X
4
This Procedure Includes the Following:
Removing/Installing Head Light Assembly
Replacing Tiller Charge Port Cover
Replacing Cushion/Front Bumper Assembly
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure that all attaching hard-
ware is tightened securely - otherwise injury or
damage may occur.
Turn Power OFF and remove key from igni-
tion. Disconnect battery harness from the
motor lead.
REMOVING/INSTALLING HEAD
LIGHT ASSEMBLY (FIGURE 1)
Removing
1. Flip the scooter onto its side.
2. Pull back the plastic guards on the RED and
BLACK cables connecting the tiller wiring har-
ness to the head light assembly (DETAIL “A”).
3. Disconnect the RED and BLACK cable metal
connectors of the head light assembly from the
RED and BLACK cable metal connectors of the
tiller wiring harness (DETAIL “A”).
4. Remove the bolt, self-locking nut, spring washer,
and washer securing the head light assembly to
the front frame assembly.
5. Separate the head light assembly from the front
frame assembly.
Installing
1. Align the bolt in the head light assembly with the
mounting holes in the front frame assembly.
2. Secure the head light assembly to the front frame
assembly using the washer, spring washer and
self-locking nut. Securely tighten.
3. Connect the RED cable metal connector of the
head light assembly to the RED cable metal con-
nector of the tiller wiring harness (DETAIL “A”).
4. Connect the BLACK cable metal connector of
the head light assembly to the BLACK cable metal
connector of the tiller wiring harness (DETAIL “A”).
FIGURE 1 - REMOVING/INSTALLING HEAD
LIGHT ASSEMBLY
Red/Black
Cables
Metal
Connectors
Plastic
Guards
Self-locking nut
Spring Washer
Washer
Head light
Assembly
Front Frame
Assembly
Bolt
5. Reposition the plastic guards over the metal con-
nectors on the RED and BLACK cables con-
necting the tiller wiring harness to the head light
assembly (DETAIL “A”).
6. Return the front frame assembly to the upright
position.
DETAIL “A”
To Tiller
Wiring
Harness
To Head
Light
Assembly