Invacare LYNX PANTHER LX-4 - Manual (Page 53)

53 53
FIGURE 6 - REPLACING HAND BRAKE
ASSEMBLY
DETAIL “A”
Bolt
Hand
Brake
Assembly
Handle
Bar
DETAIL “B”
Adjusting Nut
Cable Lock
Hand
Brake
Assembly
DETAIL “C”
Slit In
Cable
Lock
Slit In
Adjusting
Nut
Brake Cable
Brake Cable
Hand
Brake
Assembly
DETAIL “D”
Slits
REMOVING/INSTALLING FRONT
SHOCK ABSORBERS (FIGURE 7)
Removing
1. Separate the front frame assembly from the rear
frame assembly. Refer to TRANSPORTING THE
SCOOTER in PROCEDURE 10 of the Owner’s
Manual, part number 1090132.
2. Remove the front wheels. Refer to REMOVING/IN-
STALLING THE FRONT WHEELS in PROCEDURE
9 of the Owner’s Manual, part number 1090132.
3. Flip the front frame assembly onto its side.
4. Remove the TOP bolt on the right front shock
absorber.
5. Remove the BOTTOM bolt on the right front
shock absorber.
6. Slide the right front shock absorber away from
the front frame assembly.
7. If necessary, repeat this procedure for the other
front shock absorber.
Installing
1. Slide the right front shock absorber onto the front
frame assembly, aligning the mounting hole in
the bottom of the right front shock absorber with
the mounting holes in the tie rod assembly.
CAUTION
DO NOT overtighten the bolt securing the
right front shock absorber to the tie rod as-
sembly. Otherwise, damage to the right front
shock absorber may occur.
2. Install one (1) bolt through the BOTTOM mount-
ing hole in the right front shock absorber and the
BOTTOM mounting holes in the tie rod assembly.
Torque the hex cap screws between 122 - 148
in./lbs.
3. Align the mounting hole in the TOP of the right
front shock absorber with the mounting holes in
the front frame.
CAUTION
DO NOT overtighten the bolt securing the
right front shock absorber to the front frame
assembly. Otherwise, damage to the right
front shock absorber may occur.
4. Install one (1) bolt through the TOP mounting hole
of the right front shock absorber and the TOP
mounting holes in the front frame assembly. Torque
the hex cap screws between 122 - 148 in./lbs.
REPLACEMENT PARTS - PANTHER MX - 4 PROCEDURE 11
R
E
P
L
A
C
E
M
E
N
T
P
A
R
T
S
P
A
N
T
H
E
R
M
X
4
14. Install the NEW bolt securing the NEW hand
brake assembly to the handle bar. Refer to DE-
TAIL “A”. Securely tighten.