IBM AA-RWF3A-TE - Manual (Page 47)

6. Identify the screw holes to be used on the inner rails designed for the switch:
• To attach the inner rails to the SAN Switch 2/32 use the screw holes
marked 32.
• To attach the inner rails to the 4/8, /16 and 4/32B SAN Switches, use five
screw holes marked 8, and the plenum requires one screw hole marked 8
and one screw hole marked 16, as shown in Figure 15 on page 48.
• To attach the inner rails to the 4/32 or 4/64 SAN Switch, use the screw
holes marked 16, as shown in Figure 16 on page 48.
7. Assemble the two inner rails to the device using the appropriate number of screws
(see Table 5 ):
• For the 4/8 and 4/16 SAN Switches, secure each inner rail (one on each
side) to the switch using seven #8-32 x 5/16-inch Phillips pan-head SEMS
screws, as shown in Figure 15 on page 48.
• For the 4/32 SAN Switch, secure each inner rail (one on each side) to the
switch using five #8-32 x 5/16-inch Phillips pan-head screws with thread
lock, as shown in Figure 16 on page 48.
• For the 4/64 SAN Switch, secure each inner rail (one on each side) to
the switch using five #8-32 x 5/16-inch Phillips pan-head SEMS screws,
as shown in Figure 16 on page 48.
• For the 4/32B SAN Switch, secure each inner rail (one on each side)
to the switch using six #8-32 x 5/16-inch Phillips pan-head screws with
thread lock.
NOTE:
For integration in a cabinet, tighten the #8-32 x 5/16-inch Phillips
pan-head SEMS screws and torque between 6 and 8 inch-pounds.
SAN Switch installation guide 47