IBM AA-RWF3A-TE - Manual (Page 66)

Powering on and off
The following sections provide information on powering specific SAN Switch models
on and off.
4/8 and 4/16 SAN Switch models
To power on:
1. Connect one end of the power cord to the AC inlet on the switch; connect the
other end to a power source.
2. Set the AC power switch to I.
The switch runs POST each time it is powered on, reset, or rebooted. POST requires
approximately three minutes.
To power off:
1. Set the AC power switch to O.
2. Remove the power cords from the power sources.
NOTE:
Removing all power from the switch triggers a system reset. All devices are returned to
their initial state the next time the switch is powered on.
4/32, 4/32B and 4/64 SAN Switch models
Connect one or both power cords to the AC power inlets on the switch; connect the other
end to a power source.
To power on, set both AC power switches to I. Power is supplied to the switch as soon
as the first power supply is connected and powered on.
To power off, set both AC power switches to O and remove the AC power cord from
the power source.
NOTE:
Removing all power from the switch triggers a system reset. All devices are returned to
their initial states the next time the switch is powered on.
66 Managing SAN Switches