Intel SERVER SYSTEM SR2500AL - Manual (Page 81)

Intel® Server System SR2500AL User’s Guide 59
Installing the PCI Riser Assembly
1. Lower the riser assembly into place (see letter “A”).
2. Align the three hooks in the riser assembly with the matching slots at the back of
the server system (see letter “B”).
Figure 52. Installing PCI Riser Assembly into the Server System
3. Press down uniformly until the three hooks on the rear of the PCI riser assembly
engage the server system back panel slots. The riser cards will seat into the
matching sockets on the server board.
4. Connect any cables to add-in cards that require them. See your add-in card
documentation for information and add-in card requirements.
5. Re-install the processor air duct. For instructions, see “Installing the Processor Air
Duct” .
6. Install the server system cover. For instructions, see “Installing the Server System
Cover” .
7. (Optional) Install the front bezel. For instructions, see “Installing the Front Bezel” .
8. Plug all peripheral devices and the AC power cable(s) into the server.
TP02146
A
B